Resource - How to Install Marble Fireplace Mantel Surrounds

installation instruction of marble fireplaces stone fireplace surround Different marble fireplace sets have different configurations and come with different number of pieces. Therefore, installing different marble fireplaces may take different procedures. Presented in this section is the general installation guide for a popular marble fireplace style, the King Louise marble fireplace mantel and surrounds. Please be advised that all installation instructions presented in this website is solely for reference only. Please consult with your local construction professionals for more specific advises.

The following tools and accessories are needed to install a marble fireplace:

measuring tape and pencil marker

four feet long level device

putty knife and double angle brackets

1" screws; marble drill with 1" bit

marble epoxy glue

Small angle brackets - as being marked #4 in the left image, and screws

A typical and simple marble fireplace mantel surround comes with five main pieces. As marked on the image above, these pieces are:

1. Marble fireplace hearth, one piece

3. Marble fireplace side rails, also often being called fireplace side columns, total two pieces

5. Fireplace center panel, also referred as "medallion", one piece

6. Fireplace mantel, or top shelf. In some cases, top self may consist of several layers depending on its style and overall thickness.

Marble Fireplace Installation Instructions:

Step 1 Determine exact wall location of marble fireplace mantel, mark the center point. Measure the length of the hearth, part

number 1 in the image, divide this measurement by two. Starting at the center point measure out 1/2 the hearth length and mark. This

will be the edge mark for the hearth.

Step 2 Completely level the floor surface where the marble fireplace is to be installed. Place the fireplace hearth, on the leveled

surface before inserting the firebox.

Step 3 Install each side column, part number 3 in the image, make sure column bottoms match the marks found on the marble hearth.

Step 4 Secure both side to the the back wall using small angle brackets and screws (not come with fireplace). Use the level device

to ensure that each side column stand perfectly vertical, make any adjustment if necessary.

Step 5 Place the center medallion panel, part number 5 in the image, on the outer ledge of the side columns.

Step 6 Place the mantel shelve, part number 6 in the image, on the top of the side columns (3) and the medallion panel (5). Make

sure the mantel shelf is centered.

Step 7 Apply marble epoxy to glue all adjacent parts together, allow 24 hours to dry completely.